Power Station install

1. 01 Set the screwsFirst check your charger: it fits Specialized Turbo Gen 2 and Gen 3 chargers. Push the included screws through the guide holes.
2. 02 Add the spacersOptional: lightly snap the spacers onto the back if you want to wrap extra cable behind it.
3. 03 Mount itHold it level near an outlet and mark the two holes. In drywall, predrill each mark with one of the included screws, then screw the anchors in. Going into a stud or plywood? Skip the anchors and screw directly into the board. Then tighten it on.
4. 04 Drop in the chargerSlide the charger in through the side slot, coil extra cord around the spacers and set the plug on the magnetic plug mount.

Check for wiring or pipes before you drill. Don't hang above walkways, work areas, or valuables. If unsure, contact a local professional.