The OG install

1. 01 Pick your spotPick a clear wall away from walkways and workspaces, 60–70" off the floor and at least 10" below the ceiling. Check for wires and pipes before you drill.
2. 02 Mark the holesHold the Grabber level against the wall and use it as your template to mark all 6 holes. Adding more? Line the next one up on the interlocking corners.
3. 03 Set the anchorsIn drywall, predrill each mark with one of the included screws, then screw the 6 anchors in. Going into a stud or plywood? Skip the anchors and screw directly into the board.
4. 04 Screw it onLine the Grabber up over the holes and drive the 6 #8 screws until snug. Don't overtighten. Then give it a firm tug to make sure it's solid.
5. 05 Load your gearDry gear only. Hang skis at the point where they touch each other. Hang snowboards with the binding below the arms. If a board slips, flip it so the binding sits above them. A strap adds extra hold. Check everything over the next 24 hours.

Check for wiring or pipes before you drill. Don't hang above walkways, work areas, or valuables. If unsure, contact a local professional.